Get outstanding 3D printing results when you use 1.75mm PLA Plus+ 3D Printer Filament from Monoprice!

PLA Plus+ is a good choice for a printing material if you are looking for high accuracy and high resolution. It does not require a heated base and has a very low shrinkage rate (0.3%). PLA Plus+ is stronger than ordinary PLA, possessing the same strength as normal ABS material. Additionally, PLA Plus+ is a plant-based plastic, which means that it is biodegradable and gives off a slightly sweet odor, like roasting corn.

This 0.5kg spool features a thickness of 1.75mm x 0.10mm, with a roundness variation of only 0.03mm. It has a nominal processing temperature range of 205 ~ 225°C (401 ~ 437F). Thickness and roundness factors are laser measured at the factory to ensure accuracy over the entire length of the filament.

The negatives of using PLA Plus+ is that it is vulnerable to degradation from moisture, sunlight, and heat. Additionally, it is more prone to overheating during processing, which can cause dripping and drooping if it gets too hot.

Features:

PLA Plus+ is stronger than ordinary PLA, possessing the same strength as normal ABS material
Features a thickness of 1.75mm 0.10mm, with a roundness variation of only 0.03mm
Plant-based plastic, which means that it is biodegradable

Filament Type	Monoprice™ PLA+
Print Temperature (°C)	205‑225
Bed Temperature (°C)	No Heat (60‑80)
Density (g/cm³)	1.24
Distortion Temperature (°C, 0.45 MPa)	52
Melt Flow Index (g/10 min)	2 (190°C/2.16kg)
Tensile Strength (MPa)	60
Elongation at Break (%)	29
Bending Strength (MPa)	87
Flexural Modulus (MPa)	3642
IZOD Impact Strength (kJ/m²)	7

Support Files:

Filament Comparison Chart (180416)

Monoprice™ and all Monoprice logos are trademarks of Monoprice Inc.

Account not approved